Radio Reception; Usb Device Playback - Sony DSX-A510BD Bedienungsanleitung

Stored stations and correct time are erased.
The fuse has blown.
Makes a noise when the position of the ignition
is switched.
 The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, the demonstration
mode starts.
 If no operation is performed for 5 minutes with
[DEMO-ON] set, the demonstration mode starts.
 Set [DEMO-OFF] (page 20).
The display disappears from/does not appear in
the display window.
 The dimmer is set to [DIM-ON] (page 22).
 The display disappears if you press and hold OFF.
 Press OFF on the unit until the display appears.
 The connectors are dirty (page 24).
The display/illumination flashes.
 The power supply is not sufficient.
 Check that the car battery supplies enough
power to the unit. (The power requirement is
12 V DC.)
The operation buttons do not function.
 Press DSPL and
(back)/MODE for more than
2 seconds to reset the unit.
The contents stored in memory are erased.
For your safety, do not reset the unit while you
are driving.

Radio reception

Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 Check the connection of the car antenna
(aerial).
 If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
 See [NO SERV] (page 30) for details when the DAB
signal cannot be received.
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
The SEEK starts after a few seconds of listening.
 The station is non-TP or has weak signal.
 Deactivate TA (page 12).
No traffic announcements.
 Activate TA (page 12).
 The station does not broadcast any traffic
announcements despite being TP.
 Tune in another station.
 Disable DAB announcements (page 11).
 Traffic announcements are disabled while DAB
announcements are enabled.
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Program service name flashes.
 There is no alternative frequency for the current
station.
 Press  (SEEK –/+) while the program
service name is flashing. [PI SEEK] appears and
the unit starts searching for another frequency
with the same PI (program identification) data.

USB device playback

You cannot play items via a USB hub.
 This unit cannot recognize USB devices via a USB
hub.
A USB device takes longer to play.
 The USB device contains files with a complicated
tree structure.
The sound is intermittent.
 The sound may be intermittent at a high-bit-rate.
 DRM (Digital Rights Management) files may not
be playable in some cases.
The audio file cannot be played.
 USB devices formatted with file systems other
than FAT16 or FAT32 are unsupported.*
* This unit supports FAT16 and FAT32, but some USB
device may not support all of these FAT. For details,
refer to the operating instruction of each USB device
or contact the manufacturer.
27
GB