Atag VA2113RT Gebrauchsanweisung Seite 67

Table continued from last page
Problem
The dishes are not clean.
Spots on stainless steel or silver.
Possible causes
The spray arms do not rotate.
Spray arm holes or bearings
blocked.
Unsuitable dishwashing
program.
Incorrect detergent dosage.
Old detergent. Detergent is a
perishable product.
Dishes loaded incorrectly.
Glasses and cups have toppled
over during the program.
The filters are not fitted correctly.
Drainage pump stop missing.
Some foodstuffs, such as
mustard, mayonnaise, lemon,
vinegar, salt and dressings, can
cause spots on stainless steel if
left for too long.
All stainless steel can cause
spots on silver if they come into
contact during dishwashing.
Aluminium can also cause spots
on dishes.
Troubleshooting
Action
Remove the arms and clean
them.
Check that the dishes are not
blocking the spray arms.
Clean the spray arms. See the
chapter Care and cleaning.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as
Intensive wash.
Dose according to water
hardness. Far too much or far
too little detergent results in
poorer dishwashing results.
Avoid large packages.
Do not cover porcelain with
large bowls or the like. Avoid
placing very tall glasses in the
corners of the baskets.
Place dishes to sit steady.
Check that the filter handle is
locked in the stop position. The
handle should point straight out
from the dishwasher.
Check that the coloured stop on
the right in the bottom drain is in
place. See the chapter Care and
cleaning.
Rinse off these types of
foodstuffs if not starting the
dishwasher immediately.
Consider using the One hour
program program with the
SpeedWash option.
In order to avoid marks and
tarnishing, separate dishes
made from different metals,
such as silver, stainless steel
and aluminium.
27