Maintenance; Operation - Märklin 74861 H0 Benutzerhandbuch

brackets. The brackets must be placed so that they are
centrally located under a blind or spoke track.
Please note that the installed turntable should be accessible
from below.
1. Select a suitable location for the turntable on the layout
(also enough space below; the turntable should be
accessible from below).
2. Cut the opening in the layout's benchwork (dia. ≥ 288
mm / 11-3/8"). The pattern included with the turntable
will help in positioning the turntable exactly.
3. Install the required spoke tracks on the turntable and
check the appropriate detection pins (see also figures 5
& 6).
4. Lay the turntable in the opening. Now suitable locations
for the mounting brackets can be marked on the
benchwork.
5. Put the turntable aside and screw the mounting bra-
ckets on the edge of the opening.
6. Make the electrical connections for the turntable.
7. Install the turntable and connect it to the tracks provi-
ded for it.

Maintenance

The 74861 turntable requires no maintenance.

Operation

The 74861 turntable 74861 is equipped with a multiprotocol
decoder. As delivered from the factory, the decoder is set
for operation with MM/mfx. The decoder can be changed
to DCC operation in the Configuration (ex. with the Central
Station 3). The address can also be adjusted here.
The addresses 225 for MM (
are preset.
The turntable can be equipped with a maximum of 2 x 15
spoke tracks. Starting with Track 1, the possible spoke
tracks are consecutively clockwise (page 4, figure 6). After
first setting the direction of rotation, you can move the deck
directly to the individual tracks or in steps.
Entries are confirmed by the turntable using various beeping
sounds.
Normal entry
Programming successful
Errors
Operation with the Central Station 3
The 74861 turntable must like other mfx-capable accessory
items be registered using the function „Search mfx Items".
After that, Track 1 must be defined and the turntable must
be initialized.
Operation with the Central Station 2
The turntable is initially registered in the keyboard using
the function „Search mfx Items" (keyboard, Configuration,
button . After that, Track 1 can be defined immediately and
the turntable can be initialized.
= ^
keyboard 15) and 225 for DCC
Beep
Beep Beep Beep
Beep Beep Beep
13