Märklin 74861 H0 Benutzerhandbuch Seite 14

Operation with the 6021 Control Unit and 6040 Keyboard
The turntable is programmed for address 225.
After connections have been made, you can immediately
begin to define Track 1 and then initialize the turntable.
Operation with the 72760 Signal Controller (Analog Ope-
ration)
As an alternative to a digital central unit such as the Central
Station, the turntable can also be controlled with the 72760
controller. The options here are however very limited. De-
fining Track 1, the initialization and jumping from particular
tracks are not possible.
The E242325 cable can be used to connect the turntable to
the controller. However, the smaller plug (signal side!) to
it must be cut off. The turntable (ex. with a Central Station)
must be programmed to Address 1 for operation with the
72760 controller (Reprograming with the controller is not
possible!).
Programming the Turntable with the 72760 for Address 1
The programming described here always works regardless
of which address is set at the beginning. The programming
begins about one second after the voltage is turned on.
Turn Button 1 on
Turn Button 2 on
Turn Button 3 on
Turn Button 4 on
With the opposite procedure (Button 4 on, Button 4 off, ...),
the turntable can be set back to address 225.
14
turn Button 1 off
turn Button 2 off
turn Button 3 off
turn Button 4 off
Define Track 1 itself (not with 72760)
1. Run onto desired Track 1
2. Turn off layout („STOP" on controller)
3. Turn layout back on and within 5 seconds press the
buttons <clear><input><clear>
Note: The turntable accepts no switching commands as
long as the locking feature for the deck is open.
Initializing (not with 72760)
When initializing, the turntable rotates a complete circle and
evaluates the spoke tracks. The turntable thus remains only
at actual spoke tracks.
If you change the order of the spoke or blind tracks on the
turntable, the turntable must be initialized again.
The initialization can be started within 5 seconds using the
buttons <end><input><end> after turning the layout on.
Operation with DCC
The 74861 turntable is preset for operation using MM /
mfx. It can be reprogrammed to DCC. This is only possible
however with the Central Station 2 / 3 using mfx. It can also
be reprogrammed back. Reprogramming for operation with
the 72760 control box using DCC is not possible.