nedis RDFM4010WT Kurzanleitung Seite 6

• Do not put hands and foreign objects inside the
product.
• Keep the product away from magnetic or
magnetized objects.
• To prevent possible hearing damage, do not listen
at high volume levels for long periods.
• Do not use any accessories that are not included.
• Do not install the product under a cupboard with a
lighting strip installed underneath.
• Do not install the product above places where
steam and water can get in contact with the
product.
• Do not use aggressive chemical cleaning agents
such as ammonia, acid or acetone when cleaning
the product.
• Do not open the product.
Inserting the batteries (image B)
1. Open the battery compartment A
2. Insert 2 AA batteries (not included).
-
Make sure to match the (+) and (-) polarity
markings.
3. Close A
t .
Installing the product under
cupboard (image C)
The cupboard floor thickness should be at least
4
8 mm.
Install the product close to a power outlet.
4
Use a screwdriver to fix the screws.
4
Use the optional feet for thin cabinet floors.
4
-
Do not plug the power cable into the power
outlet during the installation.
-
Do not use any accessories that are not included.
- Do not install the product under a cupboard
with a lighting strip installed underneath.
-
Do not install the product above places where
steam and water can get in contact with the
product.
Controlling the product
• Press the up button A
4
adjust values.
• Press the program button A
selected value.
t .
or down button A
r to
to confirm the
2
Switching on the product
• Plug the power cable A
The product switches on automatically.
4
Set the time within one minute after powering
4
by adjusting the values and confirming.
1. Press A
9 to switch to FM mode.
2. Turn A
5 to adjust the volume.
3. Press A or A
4 r
manually.
Entering standby mode
In standby mode the display will switch off
4
automatically between 23:00 and 4:59. Press
A to switch on the display for 5 seconds.
9
• Press A
9 to switch the radio to standby mode.
• Press A
9 again to switch off standby mode.
Setting the time and alarm
1. Switch the product to standby mode.
2. Press and hold A
2
12H or 24H shows on the display.
4
3. Select one and confirm.
4. Set the current hours and confirm.
5. Set the current minutes and confirm.
The alarm icon shows on the display and the
4
hour digits will start to flash.
6. Set the hours for your alarm and confirm.
7. Set the minutes for your alarm and confirm.
BUZZ shows on the display.
4
8. Select BUZZ for a buzzer or TUNE for radio as
alarm and confirm.
U shows on the display when choosing TUNE.
4
9. Adjust the volume with A
Switching the alarm on/off
1. Press A
2 to switch the alarm function on or off.
An alarm icon shows on the display when the
4
alarm is on.
When the alarm goes off, press A
4
off the alarm.
Saving radio presets
1. Press and hold A
4
automatically.
2. Press and hold A
2
change to save stations automatically.
6
e into the power outlet.
to adjust the FM frequency
.
/ A
4 r and confirm.
to switch
9
or A
r to search for a station
until the frequency starts to