Glomex Pandora V8000 Montage- & Bedienungsanleitung Seite 63

PANDORA V8000
5. Intermittent images for short
periods
6. The equipment does not find
the satellite (the led on the
control unit is red)
7. The equipment does not find
the satellite (the led on the
control unit flashes
nately red and orange)
8. The equipment does not find
the satellite (the led on the
control unit is orange and
remains orange also when
moving the vehicle)
9. Disturbed images
10. Confused, incomplete
obstructed images
11. The decoder blocks
- the satellite
obstructed by masts of other
boats, bridges,
equipment, etc.
- the boat is at the boundary of
the coverage area
- bad weather conditions
- the satellite
obstructed by masts of other
boats, bridges,
equipment, etc.
- the boat is outside the signal
coverage area
- the boat is heaving within the
first 60 seconds after turning
on the equipment
- bad weather conditions
- inner failure
- the satellite
obstructed by masts of other
alter- boats, bridges,
equipment, etc.
- the equipment software is not
up to date
- parameters in satellite commu-
nication have changed
- failure of the receiver
and - condensate or rain on the
radome, which can disturb the
signal
- bad weather conditions
- alternating current fluctuations - refer to the user manual of the
62
signals are - move the boat to allow an
unobstructed
on-board antenna
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
56 in this manual
signals are - move the boat to allow an
unobstructed
on-board antenna or correctly position
the antenna on the boat
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
56 in this manual
- turn off the equipment for 10
seconds, turn it on again and
make sure that the boat is still
or moves in a straight line dur-
ing the first 60 seconds after
being turned on
- contact the Service Centre
signals are - move the boat to allow an
unobstructed
on-board antenna
- please contact the Service
Centre to ask for the software
update by SD card
- please contact the Service
Centre to ask for the software
update by SD card
- refer to the user manual of the
receiver for assistance, spare
parts and warranty conditions.
- remove
deposits from the radome with
a fresh water jet (not under
pressure)
- Periodically
detergent suitable for dishes
(no alcohol-based detergent)
to the radome surface and let
dry up
receiver for assistance
view for the
view for the
view for the
the condensate
apply a liquid
www.glomex.it