Scandomestic SFS 352 W Bedienungsanleitung Seite 18

6 Place freezer flatwise, remove part (3) and then loose screws (4).
Remove part (2) and part (1).
7 Screw out lower hinge, change it to the near hole site, and then
screw up and mount washer.
8 Just remount to the step 6, change part (1) to right and part (2) to
left and then fix them with screws (4). Finally install part (3).
9 Exchange wires both in the left and right slots of refrigerator body.
10 Move the door to appropriate position, adjust part (1) (which is in
the plastic bag) and the door, Mave the connecting wire (2) in the
slot of the door from left to right, and then fix part (1) and wire
(2)by screws (3). (Please hold the door by hand when installing)
11 Connect electrical connector (1) in accordance with step 3 and then
install part (2) (which is in the plastic bag).
12 Reverse part (1) by 180°and install it onto the left corner of the
door, then mount part (2). (both of which are taken down in step
2)
13 Take the reed switch out of the coping block (part (3) in step 3) and
mount it on another block for use (which is with mark "L" in the
plastic bag). Put the coping block just removed back to the plastic
bag.
Note: Be sure character side of reed switch fits well with coping block.
14 lnstall part (1), connect the wire connector (2), and then install part
(3).