Display Lighting - JGC -URCD-20 Bedienungsanleitung

Volume
• Set the desired volume by turning the volume control (23) on the device.
• To reduce the volume, turn the control in the direction of MIN..
• To increase the volume, turn the control in the direction of MAX..
• Warning: Extremely high volume can lead to permanent hearing damage due to excessive sound pressure.
Connecting an external device
• Using the AUX IN socket (20), an external music player (e.g. MP3 player) can be connected to this device
and music can be played over the loudspeakers.
• Attention: Before connecting your external playback device, please also read the operating instructions for
information regarding safety instructions and usage with other devices.
• Turn off the playback device and the external playback device.
• Connect the external playback device using a stereo cable (Ø3.5 mm). The cable is not included in the scope
of delivery.
• Connect the stereo cable with the AUX IN socket (20) and put the other end into the headphone jack or
the LINE-OUT jack of the playback device. If the external device has a smaller or larger socket, then use a
corresponding adaptor (not included in the scope of delivery).
• First turn on the external device and set the volume to zero. Then turn this device on and set the volume to
zero as well.
• Slide the FUNCTION switch (22) to the operating mode BUZZER/AUX IN.
• Now you can regulate the volume of both devices. If the playback device is connected via the LINE-OUT jack
on the external device, then regulate the volume on the playback device.
• However, playback is controlled using the external device.
• Please note that if you only turn off this device, the external playback device will continue playing.
Connecting headphones
• This device is equipped with a 3.5 mm headphone jack (21) to which you can connect most commercially
available headphones or earphones (not included).
• If headphones or earphones are connected to the headphone jack, the built-in speakers will be deactivated
automatically.

Display lighting

• You can set the brightness of the display panel by means of the DIMMER switch (19) on the back of the
device.
• The panel is brightly lit, when the switch is in the BRIGHT position. In the DIM position, the display panel will
fade.
Antennas
• For FM reception, this device is equipped with a FM wire antenna (26). Unwind the FM wire antenna and lay
it out.
• A ferrite antenna has been built into this device for the AM reception. Orientate the device in such a way that
you will receive the stations with the best possible sound quality.
JGC-URCD-20-IM-DE-EN-V1.indb 29
Downloaded from www.Manualslib.com manuals search engine
BASIC FUNCTIONS
29
29/01/2010 5:26 PM