Philips HD7872 Benutzerhandbuch Seite 16

When the on/off button lights up continuously,
7
press the 1-cup button q and the 2-cup
button qq at the same time for 3 seconds
until you hear a beep. Release the buttons
as soon as their lights as well as the selected
strength go out. This means that the descaling
procedure has been activated correctly.
• The CALC light and the on/off button start
flashing to indicate that the descaling cycle
is in progress.
• During the descaling cycle, the water comes
out of the machine in intervals.
• When all the water in the water reservoir
has been used up, the descaling cycle is
finished. The on/off button starts to flash
rapidly.
Note:
D
If you press the 1-cup and 2-cup button
longer than 3 seconds, the machine does not
start the descaling cycle. If this happens, press
the 1-cup button and the 2-cup button at the
same time for 3 seconds again.
7.2 Flushing after descaling
Rinse the water reservoir under the tap and
1
then fill it to the top with fresh tap water.
16
Notes:
D
Do not refill the water reservoir with used
hot water or the used descaling mixture.
Tilt the water reservoir and place the bottom
2
back onto the machine (1). Then press the top
of the water reservoir towards the machine (2).
Place the 1-cup pod holder q with a used
3
coffee pod in it in the coffee machine. Close
the lid and make sure it is properly locked.
Put a bowl with a capacity of at least 1.5 litres
4
under the spout to collect the water.
1.5L