Led Display; Charging Time; Energy Supply - Raikko USB AccUPACK 8000TAB Bedienungsanleitung

English

LED display:

The LED display shows the charge status of the AccuPack.
1 LED lit: 10 % – 30 %
2 LEDs lit: 30 % – 50 %
3 LEDs lit: 50 % –70 %
4 LEDs lit: 70 % – 90 %
5 LEDs lit: 90 % –100 %
Charging:
Please charge the AccuPack fully before first use.
Charge the AccuPack using the mains adapter provided. Plug
the mains adapter into a socket outlet and connect the power
cable with the charging socket of the battery pack marked "IN".
The LEDs on the device light up from left to right while charging.
The number of permanently lit LEDs indicates the current
charge status. When the LEDs have stopped flashing, maximum
capacity has been reached and the battery pack is now fully
charged.
14
Downloaded from www.Manualslib.com
USB AccUPAcK 8000TAB
IN
manuals search engine
English

Charging time:

Depending on the remaining residual capacity, the charging time
can take up to 3 hours.

Energy supply:

Take the appropriate adapter and connect the standard USB port
on the AccuPack with the device to be charged. Alternatively, you
can use the USB charging cable supplied with your end device.
To charge a device with an operating voltage of 12 V, use the
socket marked "12 V" on the device and one of the adapters
provided.
Please do not charge any USB equipment via this port.
To start the charging process, switch on the AccuPack by
holding down the function key for 2– 3 seconds. The LEDs of
the display will light up briefly from left to right. The charging
process starts automatically.
Important: Switch off the device at the end of the charging
process and when not in use.
USB AccUPAcK 8000TAB
12 V Device
Adapter
Adapter
USB-Device
15