Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
1. Pull the tilt adjustment lever and position
the handle vertically.
2. Release the tilt adjustment lever.
3. Tilt the device back and transport to the
destination.
4. When transporting in vehicles, secure
the device against rolling away, slipping
and tipping according to the respectively
applicable guidelines.
Storage
DANGER
Danger of electric shock, danger of frost
Water entering the device can cause elec-
tric shock.
Water in the device can freeze and cause
damage.
Only store the device indoors.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. Store the device indoors only.
2. Remove brush or pad / pad drive board.
ATTENTION
When the work is interrupted, do not place
the device on the brush or the pad / pad
drive board for longer than 1 hour, other-
wise the brush or the pad / pad drive board
will be damaged.
Illustration K
Care and service
WARNING
Risk of injury
The device may start up unexpectedly.
Be sure to pull the mains plug out of the
socket before you start working on the de-
vice.
1. Wash dirty pads at a maximum of 60 °C.
2. Clean the casing of the device with a
damp cloth and then rub dry.
16
3. Check the mains cable and mains plug
for damage, have damaged parts re-
placed by an electrician.
Replacing the filter bag or exhaust
filter (devices with ABS suction)
1. Make sure that the mains plug is un-
plugged.
2. Unlock the lid and remove.
Illustration L
3. Move the holder anticlockwise and re-
move the filter bag downwards.
4. At the latest, after changing the filter
bag 5 times: Pull out the exhaust filter
holder and open it.
5. Replace the exhaust filter.
6. Install the exhaust filter and filter bag in
the reverse order.
Troubleshooting guide
WARNING
Risk of injury
The device may start up unexpectedly.
Be sure to pull the mains plug out of the sock-
et before you start working on the device.
In the event of malfunctions that cannot be
remedied using the following information,
please contact customer service.
Unsatisfactory cleaning results
Replace a dirty brush or pad.
Replace a worn brush or pad.
Check the suitability of the detergent
used for the application.
Check the suitability of the brush or pad
used for the application.
The device vibrates strongly
Check the brush or pad for damage, re-
place if necessary.
Check the central position of the pad on
the pad drive board, if necessary attach
the pad centred.
Check attachment of the pad, replace
pad or pad drive board if necessary.
The brush or the pad do not turn
Check whether foreign objects block the
brush or the pad drive board, remove
foreign objects if necessary.
Plug the mains plug into the socket.
The overload protection has triggered,
let the device cool down for 30 minutes.
English
Werbung
Kapitel
Fehlerbehebung
