Operation; General Operation; Auto Mode - Sygonix 2267648 Bedienungsanleitung

9. Operation

a) General operation
1. Place the air purifier on a hard, flat surface. Leave 40 cm of
clearance on all sides of the purifier.
2. Connect the power plug to a power outlet.
3. Press to turn the air purifier ON. The air purifier fan will
start automatically.
4. Optionally, press
select "auto mode, sleep mode, or set a timer.
- For best results, run the air purifier at maximum speed
for 15 to 20 minutes before using a lower speed or
"auto mode".
- Keep windows closed while the purifier is operating.
5. Press to turn the air purifier OFF.
- The air purifier will remember its programmed settings when turned OFF, and will resume these settings when
turned back ON.
- The air purifier will not recall timers.
b) Auto mode
This mode uses the sensor inside the air purifier to adjust the fan speed automatically based on air quality.
For example, if the air quality is bad, the fan will automatically be set to high speed.
• Press to turn auto mode on.
• Press or to exit auto mode.
Colour
24
to change fan speed. You can also
Air quality
Blue Very good
Green Good
Yellow Moderate
Red Bad
40 cm
Fan speed Particle amount (ug/m
Sleep
Low
Medium
High
)
3
0 - 75
75 - 115
115 - 150
150+
0-50 ug/m³ 0-50 ug/m³ 0-50 ug/m³ 0-50 ug/m³ggd