Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; General Operation; Auto Mode - Sygonix 2267649 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

9. Operation

a) General operation
1. Place the air purifier on a hard, flat surface. Leave 40 cm of clear-
ance on all sides of the purifier.
2. Connect the power plug to a power outlet.
3. Press
to turn the air purifier ON. The air purifier fan will start
automatically.
4. Optionally, press
auto mode, sleep mode, or set a timer.
- For best results, run the air purifier at maximum speed for 15 to
20 minutes before using a lower speed or auto mode.
- Keep windows closed while the purifier is operating.
5. Press
to turn the air purifier OFF.
- The air purifier will remember its programmed settings when turned OFF, and will resume these settings when
turned back ON.
- The air purifier will not recall timers.
b) Auto mode
This mode uses the sensor inside the air purifier to adjust the fan speed automatically based on air quality.
For example, if the air quality is bad, the fan will automatically be set to high speed.
• Press
repeatedly until the "A" (auto mode) light turns on.
• Press
or
to exit auto mode.
Colour
24
to change fan speed. You can also select
Air quality
Blue
Very good
Green
Good
Yellow
Moderate
Red
Bad
40 cm
Fan speed
Particle amount (ug/m
Sleep
1 Low
2 (medium)
3 (high)
)
3
0 - 50
50 - 100
100 - 150
150+
0-50 ug/m³ 0-50 ug/m³ 0-50 ug/m³ 0-50 ug/m³ggd

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis