Service And Repair; Specifications; General Safety; Warranty - Agatec PL-3 Bedienungsanleitung

PL3-less.qxp 12/11/09 9:59

SERVICE AND REPAIR

NOTE: Disassembling the laser level will void all warranties on the product. For service
assistance, contact your Agatec dealer.

GENERAL SAFETY

PRECAUTIONS
Laser classification
The PL3 is a Class 3 laser, manufac-
tured to comply with the internation-
al rules of safety IEC 60825-1,
2007. Although the power of the
emission of the beam is less than
5mW in Class 3R, the following
cautions are recommended:
• Do not stare directly at the beam
• Do not set up the laser at eye level

WARRANTY

The PL3 Comes with a two year warranty from Agatec except in North America where the warranty is a
One Year Over the Counter Exchange Warranty.
Agatec warrants PL3 tool against deficiencies in material and workmanship for a period of one year from
the date of purchase. Deficient products will be repaired or replaced at Agatec's option or via the
Exchange Warranty in North America. Proof of purchase is required. This Warranty does not cover defi-
ciencies caused by accidental damage, wear and tear, use other than in accordance with the manufac-
turer's instructions or repair or alteration of this product by a non authorized agent. Agatec shall not be
liable under this Warranty for indirect or consequential loss resulting from deficiencies in this product or
misuse of this product. Agents of Agatec cannot change this warranty. This Warranty may not be varied
without the authorization of Agatec.
NOTE: The customer is responsible for the correct use and care of the instrument. The customer is respon-
sible for checking the results when using this tool and should follow the instructions on checking calibra-
tion prior to starting any project. Calibration and care are not covered by any stated warranty.
This warranty statement is subject to change without notice.
More information can be found at:
www.agatec.com and www.agatec-na.com
6
Page 6
Labels
Laser light: avoid direct eye exposure
Laser Class 3
according to IEC 60825-1:2007
Max output power: <5.0 mW
Wave lenght: 630-680 nm

SPECIFICATIONS

Range*
Leveling accuracy** at 5 m / 16 ft.
Self-leveling range
Number of dots
Beam directions
Laser type
Battery type
Battery life
Auto Shut-off
Environmental protection (dust, water)
Operation temperature
Storage temperature
Size (height x depth x width)
Weight w/o batteries, w/o mount
Tripod thread
Compensation type
* Depending on light conditions ** At 20° C / 68° F
Up to 30 m / 100 ft.
± 1 mm / 0.04"
± 5°
3
Up, down, forward
650 nm, Class 3R
3 x AA (1,5 V)
20 hrs.
GB F E D I N FIN
1 hr.
IP54
-10°C to 50°C / 14°F to 122°F
-20°C to 70°C / -4°F to 158°F
110 x 58 x 100 mm
4 1/2" x 2 1/4" x 3 7/8"
415 g / 0.91 lbs.
1/4"
Magnetically dampened
7