Control Panel - Kärcher WRS 200 Benutzerhandbuch

High-pressure cleaner
1
Pressure control
2
Pressure gauge
3
Oil filler opening
4
1. The high-pressure cleaner is intended for use as a hot
water high-pressure cleaner for the elimination of weeds
and as a cold water high-pressure cleaner for cleaning
regions that are difficult to access.
2. The water jet is applied using a high-pressure gun with
spray lance and a corresponding nozzle attachment.
3. Weed elimination can also be performed over larger ar-
eas using an optional front bar. Contact Kärcher for
more information.

14.2 Control panel

The work temperature can be preselected at the tempera-
ture controller.
The burner does not switch on until the blower switch is
switched on.
ATTENTION
Risk of damage
Temperatures above 100 °C may only be selected when
the pressure is set to less than 32 bar.
Temperature controller
1
Burner blower on/off switch
2
Battery malfunction indicator
3
Warning light: cleaning container or fuel tank empty
4
Note
When the warning light comes on, the burner switches off
Temperature setting 98°C
5
For fighting weeds
1. Set the temperature control to 98 °C and switch on the
blower for fighting weeds.
Switch off the blower switch immediately on completion
of work to prevent the battery from being drained.
28
2. For cold water high-pressure cleaning, turn the temper-
ature control all the way to the left and switch off the
blower.
14.3 Battery
The WRS 200 is equipped with an integrated battery that
is charged by an alternator.
The battery is required for starting the burner.
Battery
1
Minus terminal
2
1. Please consult the operating instructions of the carrier
vehicle for information on care, maintenance and safe
handling of batteries.
2. When storing the device for longer than 1 month, dis-
connect the minus terminal of the battery and recharge
the battery every 2 months.
14.4 Eliminating weeds
CAUTION
Risk of damage
Temperature settings above 100°C (steam stage) are not
permitted for eliminating weeds. See "Steam stage" chap-
ter.
Vehicle settings:
● PTO 40 litres/min
● Engine speed at least:
MIC 35/42: 2250 rpm
–
MIC 50/70: 2100 rpm
–
MC 130: 2400 rpm
–
MC 250: 1200 rpm
–
● Deactivate the seat contact switch (when working with
the standard high-pressure gun and spray lance acces-
sories)
The procedure differs from vehicle to vehicle and the vehi-
cle operating instructions must be consulted.
WRS 200 settings:
● Set the temperature controller to 98 °C
● Switch on the blower
● Fit the desired accessory (optional) to the spray lance
● Adjust the pressure control at the spray lance or at the
high-pressure pump as required.
14.5 Steam stage
The steam level is not intended for eliminating weeds.
CAUTION
Risk of damage
With temperature settings above 100°C (steam level), you
must set the pressure control at the high-pressure pump to
the minimum setting.
English