Herunterladen Inhalt Inhalt Diese Seite drucken

Pre-Commissioning; Risk Of Injury - Kärcher WRS 200 Benutzerhandbuch

Vorschau ausblenden Andere Handbücher für WRS 200:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
1. Use the lift truck to position the WRS 200 approximately
30 cm in front of the adapter and then lift it until it is po-
sitioned above the adapter.
Hydraulic hoses
1
Water connection
2
Cable with plug
3
2. Connect the hydraulic hoses to the WRS 200 and insert
them into the PTO hydraulic connection on the vehicle
(observe the correct flow direction and, if applicable, the
colour encoding).
3. Connect up the water hose.
4. Insert the cable with plug into the trailer socket.
Screw (retainer)
1
WRS 200
2
5. Slowly move the WRS 200 forwards as far as it will go
and then lower it into the adapter coupling triangle.
6. Secure the WRS 200 with the screw. Tightening torque
80 Nm.
Figure: Upper link fastener for platform C
Upper link adjusting nut
1
Lock nut
2
Retaining pin with retaining clip (platform C)
3
7. Attach the left-hand and right-hand upper links to the ve-
hicle.
a Platform C: Attach using the existing retaining pins on
the vehicle and secure with the clips (see illustration).
b Platform D and E: Attach to the vehicle using screw,
washers and nuts (included in scope of delivery) (see
illustration).
Figure: Upper link fastener for platform D and E
Upper link adjusting nut
1
Lock nut
2
Screw with washer and nut (platform D and E)
3
8. Adjust the position of the WRS 200 using the adjusting
nuts and secure with the counter-nuts.
12

Pre-commissioning

WARNING

Risk of injury

Check that the battery, accessories, supply lines, water fil-
ter and connections are in a correct condition before using
the device.
Only use the device when it is in a correct condition.
1. Check the filling level in the fuel canister and fill if nec-
essary.
2. Check the filling level in the system care container and
fill with RM 110 if necessary.
3. Check the filling level in the water tank and fill if neces-
sary.
4. A licence plate (repeater licence plate) must be attached
before use on public roads. The license plate must be
attached centrally with a 40 mm clearance, parallel to
the tail lights.
12.1 Refuelling
DANGER
Explosion hazard due to overflowing fuel
Take care ensure that no fuel spills onto hot surfaces when
refuelling.
DANGER
Explosion hazard due to smoking and naked flames
Ensure strict prohibition of smoking and open flames dur-
ing the refuelling procedure.
WARNING
Health risk from inhaled vapours
Do not refuel in confined spaces.
English
25

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

2.200-000.0

Inhaltsverzeichnis