Startup; Connecting The Water Hose; Operation; High-Pressure Cleaner - Kärcher WRS 200 Benutzerhandbuch

Note
Up to 10 °dH
Position 2
4
Note
Up to 55 °dH
3. Adjust position 1 to 2 for the desired degree of water
hardness.
Higher positions are irrelevant because these degrees
of hardness do not occur.
4. Attach the cover.
5. Attach the bar.
13

Startup

WARNING
Risk of injury from high-pressure jet or electric shock.
Check that the device, accessories, supply lines and con-
nections are in a correct condition before using the device.
Only use the device when it is in a correct condition.
13.1 Connect the high-pressure hose and high-
pressure gun
The high-pressure hose is stored in a storage compart-
ment behind the right-hand door.
The high-pressure gun with spray lance is located in hold-
ers attached to the left front side of the WRS 200.
High-pressure hose
1
High-pressure gun
2
Left door rubber latch
3
Door handle
4
Holder with rubber latch
5
Spray lance
6
Mounting
7
1. Release the rubber latch on the right-hand door (at the
top side) and open the door.
2. Remove the high-pressure hose.
3. Release the rubber latch from the upper holder.
4. Remove the high-pressure gun with spray lance.
5. Connect the high-pressure hose to the high-pressure
gun.
High-pressure hose
1
WRS 200 high-pressure connection
2
Switchover valve
3
Upper position: Operation with high-pressure gun
Lower position: Operation with high-pressure gun
closed
Lower position (with front bar option): Switchover to
front bar operation
Water hose to water connection
4
6. Connect the high-pressure hose to the high-pressure
connection.

13.2 Connecting the water hose

Establish the water supply to the WRS 200 (GEKA cou-
pling). Ensure that the mains is disconnected!.
Water hose
1
WRS 200 water connection
2
Front bar connection (option)
3
1. Connect the water hose to the WRS 200.
14

Operation

ATTENTION
Pump running dry
Damage to the device
If pressure does not build up in the device after 2 minutes
then switch the device off and proceed according to the in-
structions in the chapter "Help in case of malfunctions".
ATTENTION
Risk of damage
Always keep the doors closed when working and driving.

14.1 High-pressure cleaner

The high-pressure cleaner is operated by the hydraulic
PTO connection on the vehicle.
The burner can be switched-in for generating hot water.
English 27