Kärcher WRS 200 Benutzerhandbuch Seite 26

ATTENTION
Risk of damage due to incorrect fuel
Refuel with Diesel only.
ATTENTION
Risk of damage due to the fuel pump running dry
Check the filling level of the fuel canister regularly, refuel in
time as necessary.
Note
Refill with fuel only when the canister is detached. Use only
original canisters.
Left-hand door
1
Fuel canister
2
Retaining strap
3
Tank cap with fuel lines
4
Detergent container
5
1. Release the rubber latch on the left-hand door and open
the door.
2. Release the retaining strap from the canister.
3. Open the tank cap and allow any fuel to drip off before
removing the cap.
4. Fasten the tank cap with fuel lines open at the top.
5. Remove the canister.
6. Refill with Diesel.
7. Insert the canister and secure with the retaining strap.
8. Fit the tank cap with fuel lines.
9. Close the tank cap.
10.Wipe off any spilt fuel.
11.Close the left-hand door and secure with the rubber
latch.
12.2 Filling the system care container
The RM 110 system care liquid (descaler) is a highly effec-
tive agent for preventing calcification of the heating coil
when operating with hard water. This is drip-fed dosed into
the water supply.
The dosage is set at the factory for water hardnesses of up
to approx. 30 °dH. The dosing valve can be adjusted if nec-
essary. See chapter "Adjusting dosage".
ATTENTION
Health risk
Observe the safety and handling instructions for handling
RM 110.
26
System care container
1
Cover
2
1. Open the lid of the system care container.
2. Add RM 110 system care liquid to the container, do not
overfill.
Maximum filling level is 2 cm below the filling edge.
3. Close the cover.
12.3 Adjusting the dosage
The dosage is set at the factory for water hardnesses of up
to approx. 30 °dH (position between 1 and 2). Change the
position if necessary.
Bar
1
Cover
2
1. Remove the bar by removing the 2 screws (marked with
arrows) using a socket wrench.
2. Remove the cover.
Cover
1
Dosing pump
2
Position 1
3
English