Replacement Of Prime Wheel - Flott TBSM 100 Betriebsanleitung

REPLACEMENT OF PRIME WHEEL

1. Pull belt tension lever upward.
Take off the movable cover and open the protection cover
by remove five screws, then re- move the belt.
2. Remove the motor rear cover by remove two screws.
Use screwdriver or steel bar to insert the hole at the end
of motor shaft, then hold the bar tighten and keep motor
shaft steady.
3. Use provided deep socket to plug into the nut at the
other end of motor shaft.
Turn screwdriver and socket wrench at reversed direction,
this will loosen the nut of roller.
4. Take off the nut, used prime (aluminium)
roller is removed. Reload the new prime roller.