Flott TBSM 100 Betriebsanleitung Seite 23

SAFETY RULES OVERVIEW
Failure to observe the following precautions can result in significant injuries and damages!
The use of any machine is usually associated with certain risks. If the user takes all safety information provided by this
owner's manual into account, then the possibility of the occurrence of personal injuries and/ or damages to the workpiece
and/ or the machine can be reduced significantly.
This machine was designed for specific applications. We strongly recommend that this machine is not structurally altered
or that applications are performed for which the machine was not designed. If you have any questions regarding the
application of this machine, DO NOT use this machine until you have received detailed instructions for the proper use from
your dealer or by FLOTT.
Do not leave the running machine, only in case of stand-still of machine.
Take attention to the instructions of manufacturer regarding working material and highest speed,
max feed, using of cooling materials and clamping device of workpiece.
Only for original ,,FLOTT" spare parts we will take over the guarantee of a trouble-free factory.
Before changing the grinding belt or opening the machine disconnect the machine from the mains
power supply!
Before starting the machine connect all safety devices!
The machine should be connected to the mains power supply as indicated on the machine
information plate.
Without supervision the machine should be unplugged.
The machine operator should wear tight - fitted clothes. Long sleeves should be rolled up, jewelry
and neckties should be removed prior to operation. Long hair should be tight up or covered.
Also in case of competent using and observance of all security rules there are remaining the
following risks are remaining.
Use grinding belts according to the material to be grinded.
Care must always be taken to ensure that the fingers are not trapped in the grinding gap when
holding and guiding the workpieces.
Danger due to electricity in general.
Cracked or deformed grinding belts should not be used.
The machine should be positioned and screwed on a level surface.
Before mounting the sanding belts have to be checked.
Use ear protections!
Accidental contact between fingers and the abrasive wheel.
Danger due to the emission of physiologically harmful dust.
Only grind and trim degreased parts. Danger of fire!
Clean dust bag and filter regularly. Danger of fire!
Grinding and polishing of aluminium parts and its alloys.
Raised aluminium and magnesium dust can cause explosions, if there is an ignition source, like sparks
or a burning cigarette.
Hence it is necessary to exhaust the grinding dust with a separate extraction system and to prevent
deposition of dust in the tubes.
Alternating grinding of spark arcing and non spark arcing materials is only permitted on especially
furnished grinding equipment. The grinding equipment must be provided with separate grinding areas
and extraction systems suitable for the different dusts. In addition particular maintenance and purging
intervals have to be observed. Grinding equipment for alternating grinding must be flagged accordingly.
Information on particular protective measures necessary for the grinding of aluminium and its alloys
can be given at the competent offices of Technical Control of the respective German employer´s liability
insurance associations. Details can also be viewed in the „Richtlinien zur Vermeidung der Gefahr von
Staubbränden und Staubexplosionen beim Schleifen, Bürsten und Polieren von Aluminium und seinen
Legierungen" (guidelines for reporting the dangers of dust fires and dust explosions when grinding,
brushing or polishing aluminium and its alloys) (ZH 1/32).