Troubleshooting - Blaupunkt UVirus Killer Bedienungsanleitung

BAP-IT-H3148-U31W

TROUBLESHOOTING

This section lists the possible issues that may arise when using this product. If you can't solve
the problems based on the below information, please contact our customer centre or your
dealer.
Condition Possible reasons
The front panel may not be installed.
Machine doesn't Power plug is not inserted into the wall
turn on socket.
The power plug or cord is damaged.
The device is not turned on.
The fan is damaged.
The machine is on an uneven surface.
The fan doesn't
There are loose or foreign objects inside
work
the machine.
The motor is faulty.
The filter plastic packaging has not been
removed.
Washable mesh filter is dirty.
Filters have not been replaced.
Inlets or outlets are blocked.
The filter plastic packaging has not been
removed.
Poor
performance
There isn't enough space around the
machine.
Filter missing or incorrect filter sequence
The area is too big
www.blaupunkt.com
Possible solutions
Remove the front panel then install it again.
Pull out the power plug, then reinsert into the
wall socket.
Contact our customer centre or your dealer.
Connect to power and turn the machine on
again.
Contact our customer centre or your dealer.
Move the device to a flat surface.
Contact our customer centre or your dealer.
Contact our customer centre or your dealer.
Remove the plastic packaging of each filter.
Please clean the mesh filter.
Replace with a set of new filters.
Contact our customer centre or your dealer.
Remove the plastic packaging of each filter.
Ensure the machine has at least 50cm of
clearance on both sides of the air inlet and the
outlet at the back of the machine has at least
10cm.
Ensure that all the filters have been installed in
the correct sequence
Make sure to use the machine in a suitable area
22