Troubleshooting - Blaupunkt Lavender 2041 Bedienungsanleitung

TROUBLESHOOTING

This chapter summarises the most common problems you could encounter with
the appliance. If you are unable to solve the problem with the information below,
contact the Consumer Care Centre in your country.
PROBLEM
Back cover can not be fastened in place.
The appliance
Power plug is not connected to a power supply.
doesn't work
The machine is not turned on.
Filter's plastic packaging haven't been removed.
Air quality is good ,and the Auto mode has
been activated .
Outlet airflow
significantly
Sleep mode automatically start , the LED indicator
reduced
turns off. Meanwhile the fan speed and the noise is
than before
also reduced.
The Pre-filter is too dirty.
The filter haven't be replaced.
No suitable clearance and space for ventilation in the
surroundings .
Fan speed can't Air quality sensor become damp, the indoor
adjust temperature is too high, which make the sensor
automatic surface from a condensate .
www.blaupunkt.com
POSSIBLE CAUSE
15
POSSIBLE SOLUTION
Removing the back
reinstall it.
Unplug and then plug the power
again.
Plug in the power and turn on the
machine again .
Filter's plastic packaging haven 't
been removed. before use.
At the Auto mode ,the machine will
automatically adjust the fan speed
in the order to achieve energy
saving.
Press the button and choose the
favourable fan speed.
Please clean up the Pre-filter.
Replace a new filter.
Make sure all the rear and up sides
each has 40cm space left.
Keep the air quality sensor clean
and dry .
LV 2041
cover and