Replacing The Cutting Head; Initial Operation - Storch 21 28 35 Handbuch

Replacing the cutting head

NOTE:
Make sure that the safety switch is in the Off position
before replacing the shearing head.
1. Lift the knob in the housing above the shearing
head (2) and hold it up while removing the shearing head.
2. Install the desired shearing head by pushing it into the
tool until it engages, as shown in the image.
1. Switching on the device: Push safety switch (3) for-
wards and switch to On. Press the On/Off switch lever
(6).
2. Switching off the device: Release the On/Off switch
lever and push the safety switch into the Off position.

Initial operation

Maintain proper footing and balance at all times. This
enables better control of the device tool in unexpected
situations.
Wear appropriate clothing. Keep your hair, clothing and
gloves away from moving parts. Loose clothes, jewellery
or long hair can be caught in moving parts.
Before using the device for the first time, remove the
charger from the socket and disconnect the device from
the charger. The shears will not work if they are still con-
nected to the charger.
Switch on the device.
Allow the cutting blades to move freely for a brief
moment before starting to cut.
Do not apply to much pressure on the tool. The perfect
cut can be best made when there is no great resistance.
Both straight and curved cuts can be made with great pre-
cision.
Open
On
The cutting blades become hot during use; do not touch
them under any circumstances until they have cooled
down fully.
As soon as the blades become blunt, the cutting resi-
stance increases and the cut will not look neat. We
therefore recommend that you replace the shearing head
in a timely manner.
The following maximum material strengths must be
observed in order to avoid damage to the shearing head:
Cotton 2.5 mm
Felt 6.0 mm
Leather 3.5 mm
Carpet 3.5 mm
Vinyl flooring 3.5 mm
Corrugated
cardboard 5.0 mm
Solid cardboard 1.8 mm
37
Lock
Off
Original instruction