Bosch GWS 18V-10 PC Professional Originalbetriebsanleitung Seite 28

28 | English
Operation
Start-up
Inserting the battery
Push the charged battery (8) into the base of the power tool
from the front until the battery is securely locked.
Switching On/Off
To start the power tool, push the unlocking lever (10) for-
wards and then push the on/off switch (6) up.
To switch off the power tool, release the on/off switch (6).
Always check abrasive tools before using them. The
u
abrasive tool must be fitted properly and be able to
move freely. Carry out a test run for at least one
Speed Preselection (GWS 18V-10 PSC)
You can use the button for speed preselection (35) to preselect the required speed, even during operation. The information in
the table below describes the recommended values.
Material Application
Metal Brushing, removing rust
Stainless steel Grinding
Metal Rough grinding
Metal Cutting
Stone Cutting
The values specified for speed levels are guide values.
The rated speed of the accessory must be at least
u
equal to the maximum speed marked on the power
Status Indications
Battery charge indicator Meaning/cause
(user interface) (33)
Green Battery charged
Yellow Battery almost empty
Red Battery empty
1 609 92A 4B2 | (09.05.2018)
minute with no load. Do not use abrasive tools that are
damaged, run untrue or vibrate during use. Damaged
abrasive tools can burst apart and cause injuries.
Kickback stop
red.
To restart the tool, set the on/off switch (6) to the off posi-
tion and then switch the power tool on again.
Restart protection
The restart protection feature prevents the power tool from
uncontrolled starting after the power supply to it has been
interrupted.
When restart protection is activated, the status indicator
(36) flashes red.
To restart the tool, set the on/off switch (6) to the off posi-
tion and then switch the power tool on again.
User interface (see figure D)
The user interface (5) is used to preselect the speed and to
indicate the status of the power tool.
Application tool Speed preselection
level
Cup brush 1
Fibre disc 2
Grinding disc 3
Cutting disc 3
Diamond cutting disc and 3
cutting guide (cutting
stone is permitted only
with a cutting guide)
tool. Accessories running faster than their rated speed
can break and fly apart.
If there is a sudden kickback in the power tool,
e.g. jamming in a separating cut, the power
supply to the motor will be interrupted elec-
tronically. The LED work light (4) then flashes
white and the status indicator (36) flashes
GWS 18V-10 PSC
[rpm]
4500
6000
9000
9000
9000
Solution
–
Replace or charge battery soon
Replace or charge battery
Bosch Power Tools