Information; Troubleshooting - Vision Aqua Verdanium MAX Gebrauchsanleitung

Information

You can remedy most of the faults and errors that can occur in daily operation yourself. In many cases, you
will be able to save time and cost as you do not have to call technical service. The following table is intended
to help you understand the causes of an error and how to rectify it.
Problem
The display is dark.
The Verdanium
ricity.
The display shows "insufficient The water supply is insufficient.
water". The Verdanium
enough water.
No water is coming out of the with- The water supply is interrupted.
drawal tap.
The Verdanium
enough water.
The tube to the withdrawal tap has
a kink.
Unusual pump noise. No error! Slurping sounds at the beginning and at the end of water pro-
duction is normal.
MAX
Water from the Verdanium is No error! These are oxygen and hydrogen bubbles which can arise during
milky. the reverse osmosis. It is a sign of excellent filtration!
MAX After the initial commissioning, the
Water from the Verdanium
recommended additional 7 - 10 mi-
contains sediments after the initial
nutes of operation have not been
commissioning.
adhered to.
Wastewater runs without interrup- Check all devices connected to the
tion into the drain. Verdanium MAX
There is little water coming out of - Another connected device is with-
the withdrawal tap. drawing water at the same time.
- The reverse osmosis membranes
may be blocked.
Water runs into the drain after the No error! The Verdanium
withdrawal tap has been closed. king water during the next usage.
MAX One of the pressure sensors in the
The Verdanium operates
without interruption although all Verdanium MAX
connected devices do not withdraw
water.
Instruction Manual – Verdanium

Troubleshooting

Cause Solution
MAX Please check:
has no elect-
- The power cable is plugged-in
- Main switch setting is on (I)
- The fuse is OK
- Power outlet has electricity
Please check:
MAX receives not - The water supply (angle valve) is
open
- Minimum water pressure of 150
kPa (1.5 bar) is available
- The water supply tube 3/8" has
no kinks
- The filter is not blocked
- The pre-filters are correctly
installed.
Please check:
MAX - The water supply (angle valve) is
receives not
open
- Minimum water pressure of 150
kPa (1.5 bar) is available
- The water supply tube 1/4" to the
withdrawal tap has no kinks
- The power cable is plugged-in
- Main switch setting is on (I)
- The fuse is OK
Open the withdrawal tap of the
MAX
Verdanium and operate the
filter for 7 – 10 minutes.
Disconnect water supply.
. Contact authorised service provi-
der *
In case of blocked membranes,
please contact your authorised
service provider.
MAX is rinsing itself to produce ultra-pure drin-
Disconnect the power cord and clo-
may be damaged. se the water supply (angle valve).
Contact your authorised service
provider.
MAX – Ver. 1.1.2 – 12.2020 63