Installation; Hydro-Stopper - Vision Aqua Verdanium Max Gebrauchsanleitung

Installation

To install the Hydro-Stopper, proceed as follows:
Insert an AA LR 6 alkaline battery into the Hydro-Stopper and mount it with the sealing strainer inserted
onto the angle valve of the cold-water connection. Do not use rechargeable batteries in the Hydro-Stopper,
only use an AA LR 6 Alkaline battery, as it will not discharge on its own and will last for a year in the Hydro-
Stopper without any problems. Screw the connection adapter 3/4" to 3/8" tube onto the Hydro-Stopper.
Place the sensors of the Hydro-Stopper at the lowest point of your built-in kitchen cabinet.
Change the AA LR 6 battery after each filter change or at least yearly.
Both the connection to the angle valve and the Verdanium
and should be installed with particular care. Check that both connections with the angle val-
ve opened are leak-proof.
Instruction Manual – Verdanium

Hydro-Stopper

Angle valve
Sealing strainer of the Hydro-Stopper
Hydro-Stopper
Item No.: 1000016
Plastic tube 3/8"
Item No.: PE-12-EI-0500F-B
To the Verdanium MAX input
Connection adapter 3/4" to 3/8" tube
Item No.: NC2249
MAX is under full water pressure
MAX – Ver. 1.1.2 – 12.2020 41