Abus TVVR41200 Bedienungsanleitung Seite 88

Configuration
Parameter
Activate SNMP
SNMP version
SNMP port
Read community Enter the "Key" according to the set-
Write community Enter the "Key" according to the set-
Trap address
Trap port
Note
SNMP is used for monitoring the device status.
For this you need SNMP software not available
from ABUS.
Confirm the settings by clicking Apply and exit the menu
with Back.
UPnP
Downloaded from www.Manualslib.com
Setting
Activate the checkbox to create a
connection to SNMP software
Version of the SNMP system
Enter the SNMP port
(Default: 161)
tings of your SNMP software.
tings of your SNMP software.
Enter the IP address of the
SNMP manager
Enter the trap port
(Default: 162)
manuals search engine
Parameter Settings
Enable UPnP Tick box to activate visibility in an IP
network.
Mapping Type Select here whether port mapping is
to be conducted automatically or
manually.
Confirm the settings by clicking Apply and exit the menu
with Back.
More settings
Parameter Setting
Alarm Host IP Network address of the PC where the
CMS is installed
Alarm Host Port Port of your CMS Station
Server Port Port for data communication (Gen-
eral: 8000)
HTTP Port Port for web server (General: 80)
Multicast IP In order to minimize traffic you can
enter a Multicast IP. The IP address
has to match the IP address of the
PC running the CMS software.
RTSP Service RTSP-port
Port (Default: 554)
Note
Server port 8000 and HTTP port 80 are the stand-
ard ports for remote clients and remote Internet
browser access.
Note
With Alarm Host IP/Port you configure the address
of your CMS software. The CMS software is noti-
fied when there is an alarm, and performs various
reactions depending on the setting.
88