Ikra EGN 2500 Gebrauchsanweisung, Originalbetriebsanleitung Seite 11

16. Troubleshooting
PROBLEM
Motor does not run
The material is not being pulled in
Downloaded from www.Manualslib.com
GB | Operating Instructions
CAUSE
Safety lock
Power outage
The material is clogging up in the
feeding funnel.
The shredding material is too soft.
The blade is blocked.
manuals search engine
SOLUTION
Tighten the hand screws well.
Check the power supply cable, the
plug and the fuse.
Shut down the shredder. Pull the
material out of the feeding funnel.
Restart the shredder and insert the
thick branches in such a way that
the blade does immediately catch
in the previous cut.
Put some wood in or shred dried
branches.
Unscrew the hand screw. Open the
shredder and remove the material
causing the clog.
GB-8