13
CHARGING RECHARGEABLE BATTERIES
The PMR can be used with 3 rechargeable NiMh AAA batteries.
When using rechargeable batteries you can use the optional adapter to charge.
14
USING THE TWINTALKER 1302
14.1 TURNING THE UNIT ON/OFF
•
To activate; press and hold
•
To switch off; press and hold
14.2 ADJUSTING SPEAKER VOLUME
SC
TX RX
14.3 RECEIVING A SIGNAL
SC
TX
RX
14.4 TRANSMITTING A SIGNAL
SC
TX
RX
14.5 CHANGING CHANNELS
The PMR has 8 available channels.
To change channels:
SC
TX RX
TOPCOM TWINTALKER 1302 DUO COMBI PACK
Downloaded from
www.Manualslib.com
Only use the AC/DC ADAPTER with "AAA" rechargeable batteries. Do not try to charge
this unit when regular "AAA" alkaline batteries are installed.
• Insert 3 "AAA" rechargeable batteries .
• Plug the small plug of the 7,5 V DC / 200 mA adapter into the SPK/MIC/CHG jack and the
other end in the electrical socket.
• Make sure that the unit is switched off in order to charge the batteries properly. There is no
charge indicator during charging at OFF mode.
NOTE: It takes approximately 7 to 10 hours to fully charge the batteries.
. The unit will "beep" and the LCD Screen will display the current channel.
again. The unit will "beep" and the LCD Screen will turn blank.
The Speaker Volume can be adjusted using
LCD.
The unit is continuously in the RECEIVE mode when the unit is ON and not transmitting. When you
receive a signal on the current channel, the RX icon is displayed.
In order for other people to receive your transmission, they must be set
on the same channel.
• Press and hold
to TRANSMIT.
PTT
• Hold the unit in a vertical position with the MICROPHONE 10 cm from the mouth and speak into the
microphone.
• Release
when you have finished transmitting.
PTT
• Press
once, the current channel number flashes on the LCD Screen.
• Press
or
to change the channel.
• Press
to confirm the channel selection and return to NORMAL mode.
PTT
NOTE: Any PMR set on the same channel can receive and listen to the conversation.
manuals search engine
TOPCOM TWINTALKER 1302 DUO COMBI PACK
/
. The Speaker Volume level is displayed on the
7