Specifications - Pioneer PDP-S11 Bedienungsanleitung

English
7
Route the speaker cords out of sight
from the front of the unit.
Route as shown in the diagram, using the wire
clamps (step 3) to secure the cords.
NOTE:
If you want to move the plasma display unit, make sure
that you remove the speaker first. In addition, do not
move the display holding on to the mounting fittings. This
can result in injury or damage to the unit.
CONNECTION TO A PLASMA
DISPLAY
1
Switch off the power of the plasma
display.
2
Use the supplied speaker cords to
connect the speaker outputs of the
plasma display to the speaker inputs on
the speaker system.
1. Remove the insulation
and twist the core ends
together.
The polarity of the input terminals is plus ª for the
red terminal (the terminal on the right side in the
following figure) and minus · for the black terminal
(the terminal on the left side in the following figure).
• After connection to the terminals, pull lightly on
the cable to confirm that the tips of the cable are
properly connected to the terminals. An imperfect
connection can cause sound interruptions and
noise.
4
Downloaded from www.Manualslib.com
2. Push the lever, insert the
cable into the hole, and
release the lever.
ª terminal (red)
· terminal
(black)
Black
To the· terminal
(Speaker output terminals of the plasma display)
manuals search engine
• When cable cores stick out and ª and · lines are
short-circuited, an excessive load will be applied to
the plasma display and the operation will stop or
trouble will be caused.
• Match the colors on the speaker cable with the
speaker terminals to ensure correct polarity. This
will result in correct stereo sound. Incorrect
polarity will result in poor, unfocused sound.
CABINET MAINTENANCE
• Use a polishing cloth or dry cloth to wipe off dust
and dirt.
• When the cabinet is very dirty, wipe with a soft
cloth moistened with water-diluted cleanser; then
wipe again with a dry cloth. Do not use furniture
wax or cleaners. They may damage the surface of
the cabinet.
• Never use thinner, benzine, insecticide sprays and
other chemicals on or near the cabinets, since
these will corrode the surfaces.
• When a chemical cloth is used, read the cautions
for the chemical cloth carefully.

SPECIFICATIONS

Cabinet : Enclosed type
Used speakers (two-way system) :
Woofer (for low tones) .............................. Oval cone type
Tweeter (for high tones) ...................... 2.5 cm dome type
Nominal impedance ..................................................... 8 Ω
Frequency Range ..................................... 60 to 20,000 Hz
Sensitivity ................................ 82 dB/W (at 1 m distance)
Permissible input :
Max. input ................................................................. 12 W
Rated input ............................................................. 2.5 W
Crossover frequency ................................................ 3 kHz
Red
External Dimensions ..... 1070 (W) x 74 (H) x 102 (D) mm
Weight ..................................................................... 2.7 kg
Accessory parts
Speaker cable .................................................................. 2
Wire clamp ...................................................................... 2
Flat countersunk head screw .......................................... 2
Hexagon socket head screw ........................................... 2
Mounting tool (Hex wrench) ........................................... 1
Speaker mounting fittings ............................................... 2
To the ª terminal
Operating Instructions .................................................... 1
NOTE:
Specifications and design subject to possible modification
without notice, due to improvements.
Published by Pioneer Corporation.
Copyright © 2002 Pioneer Corporation.
All rights reserved.