Hints And Tips - Grundig WK 5040 Bedienungsanleitung

OPERATION ______________________________
Preparation
Remove all packaging and sticker materials
1
and dispose of them according to the
applicable legal regulation.
2 Before using of the appliance for first time,
clean all parts which come into contact with
water carefully.
(See the "Cleaning and care" section).
3 Completely roll out the power cord
the power cord storage
the base
slot on the base.
4 Fill the water tank
Set the kettle on its base
5
the kettle is sitting in an upright position and
that it is sitting on the base correctly and in a
stable position.
6 Pour out the hot water and rinse the kettle
with water. This will remove any remaining
manufacturing residues from the inside of the
water tank
7 Clean kettle well before initial use and discard
water of first two boiling cycles.
Operation
Push the lid release button
1
open the lid
– The lid
2 Fill the water tank
Note
Do not place the water tank
■
while filling it with water.
J
Never fill the water tank
■
maximum level indicator or below the
minimum level indicator.
3 Close the lid
4 Place the water tank
sure that it is sitting in an upright and stable
position.
5 Insert the plug into the wall socket.
6 Press down On/Off switch
– Power on indicator
heating process begins.
12
ENGLISH
Downloaded from www.Manualslib.com
on the bottom of
K
. Pass the power cord through the
J
with water.
G
. Make sure that
J
.
G
on the kettle to
D
.
A
opens automatically.
A
with water.
G
on the base
G
above the
G
until it clicks into place.
A
on the base
G
.
I
illuminates and
H
manuals search engine
Note
Lid
A
■
heating process; otherwise the kettle will not
switch off automatically.
7 After a few minutes, the water will start to boil.
The kettle switches off automatically and On/
Off switch
- Power on indicator
from
L
Note
If you want to stop the heating manually, push
■
the On/Off switch
indicator
8 Disconnect the plug from the wall socket.
9 Take the water tank
hold it by the handle
Caution
Do not open the lid
■
splash out. Make sure that no water splashes
onto the base
10 Pour the water from the spout
or glass you want to use.
Note
If you want to continue the heating process,
■
repeat the procedure from 1 to 10.
Let the kettle cool down between each heating
■
process.

Hints and Tips

The kettle is equipped with a filter
■
filters out limestone and other residues when
the water is being poured out.
Use softened or filtered water to prevent lime
■
build-up.
. Make
J
should always be closed during the
moves upwards.
I
goes off
H
upwards. Power on
I
goes off.
H
from the base
G
.
E
as hot water could
A
.
J
. Only
J
to the cup
B
which
C