Preparation Before Use; Remove The Protective Film - Mova Z500 Benutzerhandbuch

Preparation Before Use

EN

1. Remove the protective film

Remove the protective films on the side of collision buffer and
charging dock.
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
8
3. Place the charging dock on the level ground
against the wall and connect it to a power outlet
Note:
• Keep the immediate area 1.5m in front of the charger and 0.5m to both sides of
the charging dock clear of objects.
• To ensure you can connect to the robot with your phone well, make sure the
robot and charging dock are within the range of Wi-Fi.
• Do not place the charging dock in an area with direct sunlight or where other
objects might block the signal, as this may hinder the robot from returning to
the charging dock.
4. Place the robot onto the charging dock to
recharge. The robot will turn on automatically and
begin recharging
Battery Level Indicator
• White: Battery level
is more than 15%
• Orange: Battery
level is less than 15%
Note:
• Fully charge your robot before first-time use.
• Do not install the mopping module while charging. Be extra careful with the
wet mop as it can damage the floor.
Tidy up Any
Loose Cord
6h