Abilica XS 3.0 Bedienungsanleitung Seite 11

Step 7: Assemble the Console
Refer to the following figure, loosen the Bolt on the back of the Console. Install the Console Mount
(78) onto the Handlebar (5) with Phillips Screw（79）. Install the Console (77) onto the Console
Mount (78) and tighten the Bolt on the back of the Console to secure to the Console Mount (78).
Now connect the Up Sensor Cable (80) to the back of the Console (77).
Step 8: Inspection
Before finishing installation, please inspect all the screws and nuts carefully to make sure all of
them tightened.
11