Waeco PerfectView Accessory VS200 Bedienungsanleitung Seite 22

_VS200.book Seite 22 Montag, 26. Januar 2009 2:35 14
Connecting the video splitter
7
e
e
The circuit diagram for the video splitter can be found in fig. 5, page 6:
Item
rt/sw
sw
ws
gr
rt
bl
gn
br
ge
or
1
2
3
4
22
Downloaded from www.Manualslib.com
Connecting the video splitter
Caution
Ensure that all lines are connected correctly. The control line may never be con-
nected to earth; doing so can damage the device. Make especially sure to insu-
late the bare end of the control line when it is not in use and not connected.
Caution
If you have a monitor that may only be used for 12 V and 24 V electrics, a voltage
converter must be installed.
Connection description
Red/black cable: connected positive (terminals 15, 12 V – 24 V), when
using an external monitor
Black cable: connection to earth (terminal 31)
White cable: connection to R switch-plug
Grey cable: connection to L switch-plug
Red cable: connection to +12 V up to +24 V (e. g. connected positive,
terminal 15)
Blue cable: connection to the "reverse gear" control cable on the monitor
(standby/monitor)
Green cable: control signal input for the split function
Brown cable: control signal input for activating the CA2 camera input
Yellow cable: connection to B switch-plug
Orange cable: control signal for activating the CA1 camera input with
priority
Camera connection 1 (rear view camera)
Camera connection 2 (side camera)
Output for reversing monitor (cinch)
Output for reversing monitor (DIN)
manuals search engine
PerfectView