GEZE Slimdrive SD Zusatz-Montageanleitung Seite 10

Integrierte Schließfolgeregelung Bandseite Slimdrive SD Mat. Nr. 83221, Datei 83221 SD_IS-BS_141199.p65
Continuous driving unit
Illustration:
In the factory, the base plates of the integrated closer control and the butt plate have been screwed
together to form a unit, all drives are pre-assembled.
Screw off drives again. Also loosen the rope at the locking screw.
For TS 5000 only:
Take note of the shims as distance piece for the driver (U-shaped accessory part) on the side of
the 2 closing leaf.
nd
The screwed base plates can be mounted to the lintel as a whole (see mounting instructions for
Slimdrive SD or TS 5000). Mounting dimensions and alignment are not affected by SD-IS.
Individual drives incl. intermediate cover
Illustration:
Screw drives off the base plate.
Fasten base plates of both drives in accordance with the instructions Slimdrive SD (TS 5000) using
drilling template(s).
IMPORTANT:
If the intermediate cover had already been cut to size, keep the exact distance of the drives of ± 0.2 mm!
Otherwise the cover has to be cut to size after installation and trial run. For further information see mounting
instructions for intermediate cover.
10
Models:
Butt plate
Base plate
Continuous cover
1st closing leaf left incl. Slimdrive SD-IS
2nd closing leaf right incl. Slimdrive SD or TS 5000
left 1st closing leaf incl. Slimdrive SD-IS
right 2nd closing leaf incl. Slimdrive SD or TS 5000
Base plate
Intermediate cover