Safety Advice - AEG Gourmet 6 Betriebsanleitung

If the brewing process is to be aborted prematurely,
press the button (26). The operating lamp goes out and
EN
the device will abort the brewing process.
BG
Making Coffee with Coffee Powder
DE 1. Fill the water tank.
2. Open the filter compartment and insert a paper filter.
ES Add the quantity of coffee powder you want. Close the
filter compartment.
GR
3. Set the desired number of cups with the button
4. Press the button. The symbol (14) appears on
FR
the display.
5. Press the button (18) to start the brewing process.
NL
If the brewing process is to be aborted prematurely,
PT
press the button (26). The operating lamp goes out and
the device will abort the brewing process.
Making coffee with a pre-set time
To make coffee with a pre-set time, the clock needs to be
set (see "Setting the time").
1. Make preparations according to your preference, coffee
beans or coffee powder. Pour in water and insert a filter.
2. Set the desired number of cups with the button
3. For making coffee with coffee powder, press the
button before the timer is set.
The symbol (14) appears on the display.
4. Press the timer button until the indicator time (16)
flashes on the display.
5. Use the and buttons to set the start time you
want. For making coffee with coffee beans, use the button
(24) to set the coffee strength you want.
6. To activate the pre-set time, press the start button
again. The symbol (15) appears on the display.
The pre-set time is activated.
Once the pre-set time is reached, the device switches on
automatically. The operating lamp lights up and the (17)
symbol flashes on the display.
Deactivating the pre-set time
To deactivate the pre-set time setting, press the
CANCEL button (26). The symbol (15) goes out and the
programming is deactivated. However, the pre-set time is
retained and can be reactivated at any time until a new
pre-set time is programmed or the device has been
disconnected from the power supply.
Cleaning and Care
Do not use any toxic, corrosive or abrasive cleaning
agents or scouring sponges to clean the device.
These can damage the surface.
1. Clean the filter insert and the glass jug after every
use with mild detergent and warm water or in the
dishwasher.
2. If necessary, wipe down the coffee bean compartment
(2) and the lid (1) with a damp cloth.
3. Wipe down the housing with a damp cloth. If necessary,
use a little mild detergent to remove more intense soiling.
Cleaning the Grinder Shaft
. 1. Remove the coffee beans from the coffee bean
compartment (2). (Apart from the few beans that you
cannot reach by hand.)
2. Insert a paper filter into the filter insert.
3. Press the button (18) to switch on the device.
The grinding process will start.
4. Once the rest of the coffee beans have been
ground - you can tell this from the change in the
grinding noise – stop the grinding process by pressing
the button (26) again.
5. Take out the coffee bean compartment: To do this, turn
it a little anticlockwise until it disengages. Lift it off.
6. Move the grinding fineness dial (8) to the OPEN
position.
7. Pull out the top part of the grinder (3) by the small
.
handle.
8. Clean the grinder shaft and the grinder with the
cleaning brush that is supplied.
9. Reinsert the top part of the grinder and press it down.
Make sure it is in the correct position (arrow marking).
Fold the handle down again.
10. Adjust the grinding fineness dial back to a grinding
fineness. The grinder is locked again.
11. Place on the coffee bean compartment at an angle and
turn it clockwise a little until it engages.
12. Open the filter compartment (5) to remove the paper
filter.
13. To clean the grinder shaft from below: Press the
button (19) until the symbol occurs. Press the button
(18). The coffee powder tunnel gate will open. Open the
filter compartment, use the brush to clean the residue
inside, close the filter compartment, press the button (26)
to close the coffee powder tunnel gate.
Descaling
As a precaution we recommend descaling after 60 uses.
Use only environmentally friendly descaling agent and
always follow the manufacturer´s instructions.
Fill the water tank with water and descaling agent. Place
the jug with lid on the warming place. Wait 15 minutes
then press descaling button and press START to
start the appliance. Let the water run through. Perform
two more brewing cycles with water only to allow
appliance to rinse through properly.

SAFETY ADVICE

This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children without supervision.
The appliance may only be connected to a power
supply whose voltage and frequency comply with
the specifications on the rating plate! Never use or
pick up the appliance if – the supply cord is
damaged, – the housing is damaged. The
appliance must only be connected to an earthed
socket.
If necessary an extension cable suitable for 10 A
can be used. If the appliance or the supply cord is
damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified person, in
order to avoid hazard.
DISPOSAL
Recycle the materials with the symbol. Put the
packaging in applicable containers to recycle it. Help
protect the environment and human health and to
recycle waste of electrical and electronic appliances.
This symbol on the product indicates that this product
contains a battery which shall not be disposed with
normal household waste. This symbol on the product or
AEG reserves the right to change products, information and specifications without notice.
Always place the appliance on a flat, level surface.
Never leave the appliance unattended while
connected to the supply mains.
The appliance must be switched off and the mains
plug withdrawn each time after use, before cleaning
and maintenance.
The appliance and accessories become hot
during operation. Use only designated handles and
knobs. Allow to cool down before or storage.
The mains cable must not come into contact with
any hot parts of the appliance.
Do not immerse the appliance in water or any other
liquid. Do not exceed the maximum filling volume as
indicated on the appliances. Do not use or place the
appliance on a hot surface or near source of heat.
This appliance is intended to be used in household
and similar applications such as:
– staff kitchen areas in shops, offices and other
working environments;
– farm houses;
– by clients in hotels, motels and other residential
type environments;
– bed and breakfast type environments.
The coffee maker shall not be placed in a cabinet
when in use.
No action is needed to adapt the product to 50 or
60Hz.
The product will adjust itself.
on its packaging indicates that the product may not be
treated as household waste. To recycle your product,
please take it to an official collection point or to an AEG
service center that can remove and recycle the battery
and electric parts in a safe and professional way. Follow
your country's rules for the separate collection of
electrical products and
rechargeable batteries.
EN
BG
DE
ES
GR
FR
NL
PT