Combination Nozzle - Philips FC8446 Bedienungsanleitung

caution
- Do not vacuum up large objects as this may cause the air passage in the tube or hose to become obstructed.
- When you use the vacuum cleaner to vacuum ashes, fine sand, lime, cement dust and similar substances, the
pores of the dustbag and the motor protection filter become clogged. If you notice a strong decrease in
suction power, replace the dustbag and clean the motor protection filter.
- Never use the appliance without a dustbag or the motor protection filter. This could damage the motor and
shorten the life of the appliance. Only use Philips s-bag
supplied by Philips.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly
and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence
available today.
Preparing for use
hose
1 To connect the hose, push the hose connector into the hose connection opening ('click') (Fig. 2).
2 To disconnect the hose, press the release buttons (1) and pull the hose connector out of the hose
connection opening (2) (Fig. 3).
telescopic tube
Note: You can connect any of the nozzles or accessories to the handgrip or to the tube. To do this, insert the handgrip
or tube into the nozzle or accessories while turning a little.
1 Push the handgrip into the suction tube. (Fig. 4)
To remove it, turn the handle slightly and pull it off the tube.
2 Adjust the telescopic tube to the length you find most comfortable during vacuuming. Press the slide on
the tube (1) and push the lower tube part downwards or pull it upwards (2) (Fig. 5).

combination nozzle

You can use the combination nozzle on carpet (with the brush strips folded in) or on hard floors (with the
brush strips folded out).
Hard floor nozzle
- The hard floor nozzle is designed for gentle cleaning of hard floors (Fig. 6).
crevice nozzle and small nozzle
- Use the crevice nozzle to clean narrow corners or hard-to-reach places.
- Use the small nozzle to clean small areas, e.g. the seats of chairs and sofas.
using the appliance
Vacuum cleaning
1 Pull the cord out of the appliance and insert the mains plug into the wall socket.
2 Press the on/off button on top of the appliance with your foot to switch on the appliance (Fig. 7).
Note: If you want to pause for a moment, insert the ridge on the nozzle into the parking slot to park the tube in a
convenient position (Fig. 8).
Adjusting suction power
- You can adjust the suction power with the electronic suction power control on the vacuum cleaner (Fig. 9).
cleaning and maintenance
The plug must be removed from the socket-outlet before cleaning or maintaining the appliance.
1 Clean the appliance and its parts with a damp cloth.
Do not clean any part of the vacuum cleaner in the dishwasher.
dustbags or Philips reusable dustbag or dustbags
®
EnGLIsh
9