Set point value cool/heat sensor: Here, you can set the
indoor temperature at which the installation will change
between heating and cooling operation.
Heating at subnormal room temp: Here, you can set
how much the room temperature can drop below the
desired temperature before the installation switches to
heating operation.
Cooling at excess room temp: Here, you can set how
much the room temperature can increase above the
desired temperature before the installation switches to
cooling operation.
MENU 7.5.3 - FORCED CONTROL
Here you can force control the various components in
the installation. The most important safety functions
remain active however.
NOTE
Forced control is only intended to be used for
troubleshooting purposes. Using the function
in any other way may cause damage to the
components in your climate system.
PCM S40/S42 | GB
29