Filling The Water Tank; Cool Packs; Cool - SHE SHE5AC2005 Bedienungsanleitung

FILLING THE WATER TANK

Furthermore, please note the following:
Push the blowout latch  located above the
1.
water tank upwards, so that the water tank can
be pulled out.
2. Fill the water tank with clean water, paying
attention to the fill level on the front of the
water tank :
MIN mark  The water tank must be filled to
3.
above the MIN mark so that the pump can
function properly
MAX mark  The water tank must not be
4.
filled over the MAX mark, otherwise water
could enter the inside of the appliance and thus damage electronic parts.
5. Make sure the water tank is not damp or wet on the outside, and if so, wipe it dry.
6. Then carefully push the tank back into the air cooler and turn the safety latch back.

COOL PACKS

You will receive two cool packs that can be put into the water tank for a further cooling effect.
When using the cool packs, please note the following:
1. Before use, place the cool packs in a freezer for at least 3-4 hours.
2. When inserting the cool packs into the tank, make sure that the MAX mark is not
exceeded.
When doing so, please make sure that the MAX mark is not exceeded.
Never attempt to open the cool packs for any reason. The liquid contained in it can be
NOTE
Ice cubes can also be filled into the water tank.
ATTENTION
harmful to health.
Seite 19 von 123