Commissioning; Before Using The Appliance For The First Time; Filling The Water Tank - SHE SHE10AC2001F Bedienungsanleitung

BEFORE USING THE APPLIANCE FOR THE FIRST TIME

Unpacking the Appliance
1. Open the carton and take out the appliance.
2. Remove all packaging from the appliance.
3. Unwind the mains cable completely and make sure not to damage it.
Transport wheels
For easier transport, the appliance is equipped with transport wheels.
In addition, two rollers are equipped with a locking brake to guarantee that they remain firmly
in position.
1. After the appliance has been carefully unpacked, insert the
transport rollers into the designated notches on the bottom of
the appliance.
2. To adjust the locking brakes, press the levers as follows:
PRESS DOWNWARDS  to fix the brake
PUSH UPWARDS to release the brake
INSTALLATION
Please note the following points for installation.
1. Place the appliance on a level and solid surface and adjust the locking brakes so that
the appliance stands firmly in position.
2. There must be at least a 50 cm gap to walls or other objects.
3. Before using the appliance, make sure that both the air inlet and the air outlet are free
of obstacles and are not blocked.
4. Connect the appliance to an earthed outlet.

FILLING THE WATER TANK

Furthermore, please note the following:
1. Push the blowout latch  located above the water
tank upwards, so that the water tank can be pulled
out.
2. Fill the water tank with clean water, paying attention to
the fill level on the front of the water tank:
3. MIN mark  The water tank must be filled to above
the MIN mark so that the pump can function properly
4. MAX mark  The water tank must not be filled over
the MAX mark, otherwise water could enter the inside
of the appliance and thus damage electronic parts.
5. Make sure the water tank is not damp or wet on the outside, and if so, wipe it dry.
6. Then carefully push the tank back into the air cooler and turn the safety latch back.

COMMISSIONING

Seite 21 von 156