Setting Functions; Switching The Device On - SHE SHE9KL2001F Bedienungsanleitung

You can set all functions directly on the device or using the remote control.
Depending on the set function both the indicators on the operating panel display and the
symbols on the remote control display illuminate. Point the remote control directly at the
device's front and make sure there are no obstacles between the remote control and the
device.

SWITCHING THE DEVICE ON

1. Connect the device to a grounded outlet.
2. When you switch the device on for the first time a start signal is emitted and the
device immediately switches to its standby mode.
3.
Press the
Never switch the air conditioning unit off by pulling the plug. Always use the on/off button to
switch the device off and wait a few minutes before disconnecting it from mains. This allows
SETTING MODES
Cooling mode
Ideal for cooling the room in hot and humid weather.

- button until the „COOL"-indicator lights up.
Push the

With the  and  buttons you can set the desired temperature (16-31°C)

With the -button you can choose the windspeed. You can choose between two
different windspeeds:
o HIGH  High blower level
o LOW  Low blower level

As soon as you set the desired windspeed, the indiactor lights up.
In the summer we recommend setting a room temperature between 24 and 27 degrees
Celsius. Generally it is not recommended to set a temperature far below the outside
Dehumidification mode
Perfectly suited to reducing the humidity in the room (e.g. in the spring and autumn, in humid
rooms, during rainy periods etc.).

-button until the „DEHUM" indicator on the panel lights up.
Push the

The device now starts to dehumidify the air and sets the temperature to the current
room temperature minus 2C°

SETTING FUNCTIONS

button to switch the device on. The POWER indicator lights up.
the device to perform a cycle of functional checks.
temperature.
Seite 26 von 34
NOTE
NOTE