Restore Factory Settings - HomeMatic IP HmIP-RC8 Bedienungsanleitung

Short orange
flashing
(every 10 s)
6x long red
flashing
1x orange and
1 x green
lighting (after
inserting bat-
teries)
9

Restore factory settings

The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the remote control, please
proceed as follows:
Open the battery compartment (G) on the back
•
side of the remote control. Therefore, first press
Teach-in
mode active
(for 3 minutes)
Device defec-
tive
Test display
Restore factory settings
Please enter the
last four numbers
of the device serial
number to confirm
(see „5 Start-up" on
page 29).
Please see your app
for error message
or contact your
retailer.
Once the test dis-
play has stopped,
you can continue.
37