Grundig RCD 1550 BT DAB+ Handbuch Seite 21

RADIO­MODE­________________________________
1.
Switch on the device to DAB mode.
2. PLAY/PAUSE/SEL
Press and hold the
display the menu.
3. UP DOWN
Press or
press PLAY/PAUSE/SEL­button to confirm.
4. Press UP or DOWN
DRC level from 'DRC­
off'.
5.­Press the PLAY/PAUSE/SEL
6. You may press the STOP,­ALBUM/MEMORY­UP
or DN button to exit the menu.
Removing­DAB­radio­stations­from­
the­station­list
If you move to a different part of the country, you
should remove DAB radio stations, which are no
longer available, from the station list. These DAB ra-
dio stations are marked with "?".
1.
Switch on the device to DAB mode.
2.
Pressing and holding the
ton, the LCD will show the menu of the device.
3. UP
Press briefly the
PLAY/PAUSE/SEL
"Prune", then press
confirm;
4.
The display will show "Prune", "No", "Yes". If you
want to remove the unavailable stations from the list,
UP
you can press the
"Yes,", then press the
again to confirm the removal.
5.
After these operations, you will find only available
stations are in the list.
FM­radio­mode
1. For the best 'FM'. reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
2. Press the MODE/INFO
showing 'FM'.
Automatic­tuning­FM­radio­stations
1.
Start the automatic station search by pressing and
UP or­DOWN
holding down the
stops when a station is found.
Manual­tuning­FM­radio­stations
1. To move the frequency forward or backward in
steps, briefly press UP or­ DOWN
quency changes in steps of 50kHz.
button to
button to choose DRC, then
button to choose the desired
high', 'DRC­ low', or
to confirm.
PLAY/PAUSE/SEL
DOWN
or button to choose
button to
DOWN
or button to choose
PLAY/PAUSE/SEL
button
button until the display is
button. The search
button. The fre-
Automatic­tuning­station­(ATS)
1. Activate the
MEM/STOP
changes to rapid run through.
- The device searches for up to 20 radio stations and
then saves them. After the search has finished, the
'DRC­
station stored in position 01 can be heard.
Storing­FM­radio­stations­to­presets
You can store
1. ON/OFF
Press
2.
Press and hold
desiredFM
3. PROG/MEM/STOP
Press the
preset store list.
4. ALBUM/MEMORY­UP
Press the
choose the desired preset number.
5.
Press the PROG/MEM/STOP button again to store
the FM station into preset list.
but-
Note: You can replace a station on a preset with a
new one by carrying out steps 2 to 5 as described
above.
Selecting­stored­FM­stations­from­
presets
1.
Select the FM station you want with ALBUM/MEM-
ORY UP or DN button to choose the stored stations
from presets.
Stereo­/­Mono­reception
If the device receives a FM stereo station, and if the
signal from the FM stereo station is weak, you can
improve the sound quality by switching to mono re-
ception.
1. Switch to mono reception by pressing MODE/INFO
button.
2. Switch to stereo reception by pressing this button
again.
ATS by pressing and holding
button until the frequency display
FM
radio stations on 20 presets.
button to switch on the device.
UP or­DOWN
button to tune to the
station.
button to display the
or
ENGLISH
PROG/
DN
button to
21­