Initial Operation; Connecting The Unit To The Mains - HAVER & BOECKER USC 200 S Bedienungsanleitung

5
Packing
Check for transport
damages
Placement
DANGER
Ambient conditions
5.1
Required mains
conditions
Connect mains cable
© Copyright 2017 by HAVER & BOECKER

Initial operation

Please keep the original packing or dispose of it according to
the relevant waste disposal regulations. You can also return the
packing to the manufacturer free destination (to your account).
The machine must only be sent in the original packaging for
transport (e.g. in the case of service).
Check the unit for possible transport damages before initial
operation. In case of visible damage do not connect the unit to
the mains. Contact your supplier and forwarding agent.
For operation, place the unit on a dry and solid surface. Ensure
that the workplace is sufficiently ventilated!
Do not use a soft surface (e.g. a carpet) as this may impede the
ventilation of the unit.
Risk of electrocution due to humidity inside the unit!
Protect the unit from entering humidity.
The unit inside is splash-water-proof. Keep workplace and
casing dry in order to prevent electrical accidents and damages
on the unit.

Allowed ambient temperature during operation:
+5°C - +40°C

Allowed relative humidity of air during operation: max. 80%

In-door operation only

Connecting the unit to the mains

Earth grounded socket:
1 phase (220-240 V); 1 N; 1 PE protective earth.
The power supply must be protected by an earth leakage circuit
breaker.
Use the plug-in mains cable delivered with the unit. Connect the
unit to a grounded shockproof socket only. Ensure that the
values indicated on the nameplate of the unit correspond with
the available connecting conditions.
The mains plug must be connected to an easily accessible
socket only, as it serves as interrupted device!
10.2017
Initial operation
15