Operation - Rexel Auto+ 100 Bedienungsanleitung

Autofeed Technology
The Auto+ 100 has been designed to automatically shred up
to 100 sheets from the autofeed chamber and up to 6 sheets
through the manual feed entry slot. The autofeed mechanism
has been designed to handle paper fastened with staples and
paper clips and to only pull a few sheets of paper into the
cutting mechanism to minimise the risk of paper jams.
Bin or Loading Door Open Safety
Function
As a safety precaution, if the bin or loading door is opened
during shredding, the shredder will stop and the bin full
indicator will illuminate (
Automatic Jam Clearance
In the unlikely event of the shredder jamming, the Auto+ 100
will automatically reverse and forward the engine three times to
clear a jam. During this operation the Paper Jam indicator will
flash ( ).
Rare Occasions of Jamming
If after this auto jam clearance cycle the shredder still has a
paper jam, it will stop and the jam indicator illuminate (
Try clearing the jam using the reverse (
jam boost (
loading door, remove the remaining stack of paper, then pull the
jammed paper free of the cutting mechanism.
Over Heating
If the Auto+ 100 is used continuously for over 10 minutes
the shredder may overheat and the cool down indicator will
illuminate ( ). Please allow the shredder to cool down. When
the shredder is ready to be used the thermometer symbol will
no longer illuminate. If the shredder needs to cool down while
shredding, no action is needed. The shredder will automatically
restart shredding paper once it has cooled down after periods
of continuous use. All you need to do is ensure paper is loaded
into the chamber and the bin is empty when the machine is
cooling down.
6
Downloaded from www.Manualslib.com
).
) and continuous
) buttons. If this is unsuccessful, open the
manuals search engine

Operation

After unpacking the product, pull out the shredder bin.
1
Remove and fit the recyclable paper bag (as per instructions
printed on the bag).
Connect the shredder to mains supply.
2
Ensure the on/off button on the back of the machine is in
3
the on position.
To commence shredding, press the central Auto button
4
( ). This will illuminate the blue standby symbol on the
auto button and sets the shredder into auto mode. You are
now ready to shred.
Press the loading door button to open the loading door.
5
Load up to 100 sheets at a time into the feed chamber. Do
not fill above the 100 MAX level, this could damage the
shredder (see fig 1).
Close the loading door without pressing the loading door
6
button. The shredder will now start automatically.
If there is still paper in the Autofeed tray after first attempt,
7
open and re-close paper loading door a second time.
If you only have up to 6 sheets to shred, you can use the
8
manual feed entry slot, provided the auto feed chamber is
empty (see fig 2).
If the shredder is left in auto mode for more than 2 minutes
9
without being used, it will automatically turn to sleep mode
to save power.
).
The shredder will automatically operate from standby mode
J
when paper is inserted into the manual feed entry slot.
Opening either the loading door, empting the bin or pressing
any button will return the product to auto mode.
Reverse Function
Should you wish to reverse paper out whilst shredding, a
1
reverse button (
The jam indicator will illuminate.
To resume shredding, turn the shredder on using the ON/
2
OFF switch at the rear of the shredder. Return the switch to
the auto position (
) has been fitted for your convenience.
).