Zipper Maschinen ZI-TKS315 400V Betriebsanleitung Seite 28

 Take four M4x12 hex head bolts and
four M4 washers and mount part 14 to
part 13
 Take four M4x12 hex head bolts, four
M6 washers and four M6 nuts and mount
part 16 (axle) + part 17 (pulley 2x) to
part 4 and part 5. The bolts must not be
tightened too much.
 Tighten the bolts in positions A and B
closely. Tighten the bolts in positions C
and D so that the bolt ends are in the
same level as the nuts
 Except for bolts in positions H and I,
tighten all the bolts, starting with A and
ending with G
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-TKS315_400V
ASSEMBLY
28