Device Function; Setting The Time; Alarm" Wake-Up Function - Beurer WL 50 Gebrauchsanweisung

Note
The currently displayed battery state may vary depending on the mode being used.

7. Device function

7.1 Setting the time

To set the time on the device, proceed as follows:
1. When you slide the
hour will automatically flash in the display. If the device is already in operation, press and
hold the Mode button for two seconds.
2. The hour flashes on the display.
Use the and
3. The minute flashes on the display.
Use the and
4. The time has now been set and will be displayed permanently.

7.2 "Alarm" wake-up function

Note
The device features two alarm memory spaces that can be configured individually.
On | Off switch on the device to the "On" position for the first time, the
buttons to set the hour. Use the
buttons to set the minute. Use the
36
button to confirm.
OK
OK button to confirm.