Snooze Function; Listening To The Radio - Beurer WL 32 Gebrauchsanweisung

6.5 Snooze function

When an alarm sounds, it can be stopped temporarily by
pressing the Zz button. The alarm will sound again once the
preset snooze duration has elapsed. For information on set-
ting the snooze duration, see chapter "6.1 Setting the time
and snooze duration".
6.6 Sunrise function
Having set an alarm, you can also wake up to a sunrise
simulation in addition to the alarm. With this function, the
LED light gradually becomes brighter.
Note
For this function, use the mains adapter provided.
• Press and hold the Zz button for approx. 5 seconds.
"15" will flash on the display.
• Using the  /  buttons, set the desired simulated sunrise.
15 = Sunrise simulation begins 15 minutes before the set
alarm time.
30 = Sunrise simulation begins 30 minutes before the set
alarm time.
OFF = Sunrise simulation deactivated. The lamp symbol
( ) disappears from above the time on the display.
• To confirm your selection, press the Zz button.
6.7 Lamp function/mood light with change of colour
The wake up light can also be used as a normal lamp or as
a mood light with change of colour.
Note
For this function, use the mains adapter provided. When you
are listening to the radio or have activated the goodnight
function, the "mood light with change of colour" function is
deactivated. Only light without change of colour is possible
in this mode.
• Press the Zz button.
The LED light begins to light up gradually.
• To activate the lamp function, press the Zz button again.
"L 09" will flash on the display (brightness level 09).
• Using the  /  buttons, set your desired brightness level
(L 00 to L 15).
• To activate the mood light with change of colour, press the
Zz button again.
The mood light with change of colour begins to light up.
Wait a few seconds for the colour to change.
• To set one of the mood lights permanently (without
change of colour), press the Zz button again.
• To switch off all light functions, press the Zz button again.

6.8 Listening to the radio

The wake up light has a flexible wire antenna on the rear of
the device. Uncoil the wire and extend it fully to ensure the
best reception.
• To switch the radio on, press the
20
button.