Discharging And Recharging - Himsa noah LINK Bedienungsanleitung

NOAHlink Users Manual

6.2.1 Discharging and Recharging

18
Downloaded from www.Manualslib.com
Your rechargeable battery – a NiMH battery – automatically
charges whenever it is placed in the charger cradle. However,
approximately once every three months, it is recommended that you
completely discharge, and then recharge, your battery. This ensures
that the rechargeable battery is always working to its fullest
capacity, and also helps to extend its lifetime.
NOTE: The entire process will take approximately 15 – 17 hours.
You will be unable to turn on your NOAHlink while
charging or discharging the unit‟s battery.
IMPORTANT:
Use only rechargeable batteries when NOAHlink is
placed in the charger unit. If you are using alkaline
batteries, do not attempt to charge your NOAHlink.
Your alkaline batteries may be damaged and leak,
and this may in turn cause damage to your
NOAHlink unit. Damage caused by such misuse will
not be covered by the NOAHlink warranty.
The following describes the discharging and recharging procedure:
 Place your NOAHlink unit in its charger cradle, matching
the front of the cradle to the front of your unit.
 Attach the charger cradle to the power adaptor and plug this
into a socket.
 Press the discharging button on the charger cradle. A red
light at the front of the unit remains lit while discharging
takes place.
As soon as discharging is complete, the charger cradle automatically
begins to recharge your NOAHlink and a green light is displayed.
manuals search engine