Maintenance - iRobot Roomba 500-Serie Bedienungsanleitung

Maintenance

To keep Roomba running at peak performance, it is recommended that you
perform the following maintenance regularly:
Remove and empty
1
Roomba's bin
Press button and
pull to remove bin
Clean Roomba's filter
2
compartment
A. Clean or replace filter*
B. Clean filter
*Replace filter every 2 months
TIP: Bin emptying and brush cleaning should be done after every 3-5 cleaning
TIP: If you notice Roomba picking up less debris from your floor, empty the bin
Excessive build up of hair in Roomba's brushes and bearings can
permanently damage Roomba. Inspect brush bearings regularly.
Do not attempt to run Roomba without the bearings. If you misplace
Roomba's brush bearings, contact iRobot Customer Care for replacement
bearings.
20
Downloaded from www.Manualslib.com
compartment
Visit www.irobot.com for information on keeping Roomba running at peak performance.
cycles depending on the amount of hair, dirt, and debris in your environment.
and clean the brushes.
iRobot Roomba 500 Series
manuals search engine
Clean Roomba's brushes
3
A. Remove brush guard by pulling
both yellow tabs
B. Remove brush caps and use scissors
to cut any hair wrapped around the
brush. Use the Roomba cleaning tool
to comb hair from brush.
Empty bin
C. Remove and clean hair and dirt from
Roomba's brush bearings.
Brushes
Brush
caps
Brush
caps
Brush
bearings